Electronics > Repair
Leader FG 1301 - Dirty switches
(1/1)
Muett:
Just bought a Leader 1301 Function generator and was disappointed to find that all of the push button switches seem to be dirty.  After trying multiple times I was able to finally get an occasional decent waveform on only a few the frequencies.  The range buttons seem to be the worst while the frequency dial is clean, without any noise.  The waveform buttons are also a problem but not as bad.  My question is can I clean these with Deoxit D5?  Or should I just return it (sold as “This is in good working order.”)?

Muett:
Needles to say, Deoxit brought it back to life.  Push button switches all work perfectly.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod