EEVblog Electronics Community Forum

Electronics => Repair => Topic started by: pogster on December 05, 2019, 12:05:38 pm

Title: LeCroy Wavepro 7200
Post by: pogster on December 05, 2019, 12:05:38 pm
Hi,

I have a LeCroy Wavepro 7200 that has a data acquisition error. The channel icons display "no data" and if i try and run autoset / auto trigger  then in the bottom left corner it says "stopping acquisition - communication problems"

I have done all the usual ... checked all the connectors and re-seated them, checked the supply rails on the acquisition board... all ok.

Does anyone have any experience of this fault? could it be a firmware issue?

Pete.