Author Topic: LeCroy Wavepro 7200  (Read 234 times)

0 Members and 1 Guest are viewing this topic.

Offline pogster

  • Newbie
  • Posts: 1
  • Country: gb
LeCroy Wavepro 7200
« on: December 05, 2019, 12:05:38 pm »

I have a LeCroy Wavepro 7200 that has a data acquisition error. The channel icons display "no data" and if i try and run autoset / auto trigger  then in the bottom left corner it says "stopping acquisition - communication problems"

I have done all the usual ... checked all the connectors and re-seated them, checked the supply rails on the acquisition board... all ok.

Does anyone have any experience of this fault? could it be a firmware issue?


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo