Electronics > Repair
Lecroy wavesurfer 3024 fail to boot
<< < (14/14)
tautech:

--- Quote from: ranvocd1 on June 15, 2024, 09:05:38 am ---Though I do think I can find an equivalent encoder when removed and by researching the part reference, I do not think I have the proper equipment nor skills to properly remove potentiometers that are SMD mounted without potentially damaging the board

--- End quote ---
:-//
Low temp AG solder and solder sucker or desoldering iron should handle encoder replacement with ease as it's a TH part not SMD.
I'd give it a go, and on any day of the week.
 :popcorn:
lianghx:
hello,friend ,I have one wave surfer 3054 boot loop can you help ?I need the serial console pinout
thanks
tautech:

--- Quote from: lianghx on December 11, 2024, 03:27:51 pm ---hello,friend ,I have one wave surfer 3054 boot loop can you help ?I need the serial console pinout
thanks

--- End quote ---
Welcome to the forum.

See the first few posts in this thread for the recovery tools.
With the correct tools there is no requirement to open the scope.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod