Electronics > Repair
Lecroy wavesurfer 3024 fail to boot
tautech:
--- Quote from: ranvocd1 on June 15, 2024, 09:05:38 am ---Though I do think I can find an equivalent encoder when removed and by researching the part reference, I do not think I have the proper equipment nor skills to properly remove potentiometers that are SMD mounted without potentially damaging the board
--- End quote ---
:-//
Low temp AG solder and solder sucker or desoldering iron should handle encoder replacement with ease as it's a TH part not SMD.
I'd give it a go, and on any day of the week.
:popcorn:
lianghx:
hello,friend ,I have one wave surfer 3054 boot loop can you help ?I need the serial console pinout
thanks
tautech:
--- Quote from: lianghx on December 11, 2024, 03:27:51 pm ---hello,friend ,I have one wave surfer 3054 boot loop can you help ?I need the serial console pinout
thanks
--- End quote ---
Welcome to the forum.
See the first few posts in this thread for the recovery tools.
With the correct tools there is no requirement to open the scope.
Navigation
[0] Message Index
[*] Previous page
Go to full version