Electronics > Repair
Lecroy wavesurfer 3024 fail to boot
(1/14) > >>
gkmaia:
Hi,

My Wavesurfer got stuck on a blue screen while trying to boot.

I've uploaded a video on youtube showing the issue.



Also found the scope recovery notes, but seems it do not apply to my as the Wavesurfer does not have a recovery procedure.

Cheers
Gui
kendor:
Hi,

Exact same thing happened to me two weeks ago. I was desperate ;)

Turns out you have to re-flash your scope/run a recovery disk. This is done by the Micro-SD on the back of the file.
I've uploaded you the recovery disk here: https://tmp.yxc.ch/wl/?id=8qaTN2VHKrAbuceZwjrNxd629KcMKVvS
Extract all files on an SD and boot - it will do. After recovery make sure to remove the files again, or it will do a recovery over and over again.

After recovery make sure you update your bios, with the new bios it should not enter an infinite boot loop anymore. You can download the latest firmware here:
https://teledynelecroy.com/support/softwaredownload/documents.aspx?sc=12 ( I also uploaded the latest version for a WaveSurfer 3000 in above link)

Let me know if it worked

Cheers
gkmaia:
WOW! Thanks Kendor!

Amazing, I will try it right now!
gkmaia:
I tried and it worked!!! Great tip mate. I really appreciate!
tautech:
Oh so you nabbed it and you got quite a good scope now it's recovered.
https://www.eevblog.com/forum/testgear/teledyne-wavesurfer-3024-200mhz-oscilloscope-any-good/

Investigations at the time indicated only a LeCroy recovery package would fix it.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod