| Electronics > Repair |
| LG TV turns on for a sec then shuts off... |
| << < (3/3) |
| inse:
Please re-read replies 4, 6 and 8, it’s a four stripe resistor with an additional parameter marking. Did you locate a service manual? Otherwise we have no idea which circuit parts you are talking about… Can you supply a photo ofthe PCB top and bottom side? |
| DavidAlfa:
Normally this is a burnt led, still conducting a bit but causing huge Vf, triggering OVP. |
| Lockon Stratos:
--- Quote from: inse on December 24, 2024, 09:20:24 pm ---Please re-read replies 4, 6 and 8, it’s a four stripe resistor with an additional parameter marking. Did you locate a service manual? Otherwise we have no idea which circuit parts you are talking about… Can you supply a photo ofthe PCB top and bottom side? --- End quote --- Ok. Popped off the zehner and diode from the board. Zehner is still a short both directions, the diode also measures the same..... Ill try to dig up some schematics tomorrow, this is going to take a while. Images: https://content.section9.me/im/eev/top.jpg https://content.section9.me/im/eev/bottom.jpg --- Quote from: DavidAlfa on December 24, 2024, 09:34:20 pm ---Normally this is a burnt led, still conducting a bit but causing huge Vf, triggering OVP. --- End quote --- Maybe, ill know more if i have found some sort of schematics... |
| u666sa:
--- Quote from: DavidAlfa on December 24, 2024, 09:34:20 pm ---Normally this is a burnt led, still conducting a bit but causing huge Vf, triggering OVP. --- End quote --- This. :-+ |
| Lockon Stratos:
Ill look into that as well, at least i finally found the correct info for the board i have: https://adjuntos.yoreparo.com/default/0007/06/8787c55ea551c12f230ce656a3db5ae95011a1ca.pdf (I hope the IC didnt get fried, tried mouser and digikey but nothing comes up for that part number.) Ill order the parts then i can test the led strip voltage during operation..... |
| Navigation |
| Message Index |
| Previous page |