Electronics > Repair
Maxon PM100 PMR EEPROM
david17:
Hi, I have removed the EEPROM AT93C56 from the pcb and read the code with a TL866. At the moment, all 4 channels are the same 171.43762. I would like to re-program this to 2 meters. Any idea how to work out the code needed.
Thanks, David.
coromonadalix:
well post the eeprom content first, and maybe some can or could help
david17:
000000:86\08\97\26\D6\17\86\08\97\26\D6\17\86\08\97\26\
000010:D6\17\86\08\97\26\D6\17\
000060:\C8\C8\C8\C8\00\00\00\00\00\00\00\00\00\00\00\00\
000070:00\00\20\0A\00\00\03\30\00\00\00\00\00\00\00\00
000080:\00\00\00\00\00\00\0F\00\0F\00\00\32\00\00\00\00\
000090:all FF to end
My bin file after removing a lot of 00 and FF at the end.
David
coromonadalix:
found this today scroll down to maxon ....
http://www.cqham.ru/sch_eng.html interfaces and softwares
as i see it
86\08\97\26\D6\17 is one channel
86\08\97\26\D6\17
86\08\97\26\D6\17
86\08\97\26\D6\17
for the rest ???
david17:
Yes, as my 4 channels are the same 86\08\97\26\D6\17 must = 171.43762. Would be nice to know how the hex is worked out for other frequencies.
I had found the site in the link you sent. When click on the software link I get "File not downloaded: Potential security risk." so I stopped there.
I would think the code at the bottom is the power setting and CTCSS frequency.
The interface circuit shows a 25 pin coms connector not in my radio.
Thanks, David
Navigation
[0] Message Index
[#] Next page
Go to full version