Electronics > Repair

metex 1280


I have an a problem with this meter it takes around 20 minutes to measure a 1 Meg resistor. The meter does this by first displaying the highest value its capable of reading and counting backwards ( converging to the value of the resistor being measured before counting back to its maximum residence it can measure. Can anyone please explain.

intermittent connection problem


--- Quote from: R_G_B_ on August 06, 2014, 01:17:38 pm ---intermittent connection problem

--- End quote ---
Did you get this fixed? Was the above the problem?

Yes it was the 4mm sockets not allowing the 4mm plugs to fit snuggly. By the way the scope function on this thing is pants!


[0] Message Index

There was an error while thanking
Go to full version
Powered by SMFPacks WYSIWYG Editor
Powered by SMFPacks Advanced Attachments Uploader Mod