Electronics > Repair

Micsig SATO1004 Wi-Fi not working

(1/1)

GNasty:
How is everyone today? I am new to the forum, and hopefully I posted this in the right section.  I am hoping you can point me in the right direction. I have a Micsig SATO1004 scope. I turned it on today and noticed it failed to connect to Wi-Fi.  It shows all available networks in my area, but “failed to connect” pops up on the screen. I tried using my phone as a hotspot, and I still can not connect. I thought maybe this was a firmware update issue.  I was able to connect directly through Ethernet to check for an update, but no updates were available.  Do you have any ideas on how to get Wi-Fi working again? 
Thank you for the help.

Kyle

m k:
First you must figure out somehow that scope's wi-fi is actually sending.
So you need a device that can show you wi-fi frequencies.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod