Electronics > Repair
miniDSP 2x4 HD USB DAC+DSP repair.
(1/1)
djsb:
This topic is to log my attempt to repair my miniDSP 2x4 HD USB DAC+DSP which has suddenly stopped outputting any sound. It has been turned on for a while, so maybe something in the power supply has developed a fault.

https://www.minidsp.com/products/minidsp-in-a-box/minidsp-2x4-hd?gad_source=1

I will first attach a few PCB photo's in order to aid orientation. There are no official schematics or other service information that I am aware of, so I have to try to fix this by doing some research and investigation on my own. I have made some initial checks on the op amp and linear regulator voltages, and they seem OK. I don't know where the negative supply for the audio op amps comes from. My next on the list for checking is the tps65261-1 switch mode regulator and all the yellow tantalum caps (close to the large aluminium SMD cap). There is Hiss from the amplifiers (I use 2 x stereo amps in an active filter setup) after a small delay startup, so the output stages (of which there are 4) appear to be OK. I will list the chips on this side of the PCB later.
djsb:
Here is a photo of the reverse side of the PCB. I will list the chips on this side of the PCB later.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod