Electronics > Repair
MULTIMETER FLUKE 79III
(1/2) > >>
lionelkjh:
Good evening everyone! I am trying to identify the 3-legged smd component marked "99" on the attached photo of the FLUKE79III electronic card .... I am also attaching the general photo of the multimeter ... Could someone help me?? Thank you for your patience and dedication. ;) ;) F26III_007.jpg (249.89 kB. 1024x768 - viewed 176 times.)
Kurets:
I would expect BAV99 dual diode for some kind of clamping to rail. Not sure as it would require a bit more reverse engineering.
bdunham7:
Maybe one of these:

https://www.mouser.com/ds/2/348/ta115te-1144138.pdf?srsltid=AfmBOorylFTfy4NF8wXon6jhIjqR-98V7GoIDAnGMDe2VABJk1eTf_gN
lionelkjh:
Thanks a lot! :-+ :-+ :-+
Psychodad49:
I also have a Fluke 79III and opened it up. This is what the parts in my device look like, maybe this will help you.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod