Electronics > Repair

MULTIMETER FLUKE 79III

(1/2) > >>

lionelkjh:
Good evening everyone! I am trying to identify the 3-legged smd component marked "99" on the attached photo of the FLUKE79III electronic card .... I am also attaching the general photo of the multimeter ... Could someone help me?? Thank you for your patience and dedication. ;) ;) F26III_007.jpg (249.89 kB. 1024x768 - viewed 176 times.)

Kurets:
I would expect BAV99 dual diode for some kind of clamping to rail. Not sure as it would require a bit more reverse engineering.

bdunham7:
Maybe one of these:

https://www.mouser.com/ds/2/348/ta115te-1144138.pdf?srsltid=AfmBOorylFTfy4NF8wXon6jhIjqR-98V7GoIDAnGMDe2VABJk1eTf_gN

lionelkjh:
Thanks a lot! :-+ :-+ :-+

Psychodad49:
I also have a Fluke 79III and opened it up. This is what the parts in my device look like, maybe this will help you.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod