Electronics > Repair
Need help identifying component
(1/2) > >>
vinovino:
Need help identifying the component and a possible replacement parts.
The designator says FL14, I think its a kind of filter but I don’t know what kind.
It has 3 pads underneath, the middle pad is connected to ground.
It is around 2mm size.
Please see attached images of pad and the filter itself beside a ruler.
amyk:
What is this out of?

FL20 also looks cracked.
u666sa:
FL15 looks normal. You can take it off, rig it up and measure it with NanoVNA. It's a coil, two coils with ground in the middle. Unless FL15 pin to ground does not measure as coil, then it is a capacitor, but the marking say L, so I suspect a coil.

All these 3 components should have same exact values. Measure FL15, and use two small coils (or caps if it is a cap) in place of one.
coromonadalix:
woul be as mentioned  FIlter line  smd      inductive most of the time, but some  do include capacitors  ...
fzabkar:
Could FL15 and FL20 (and FL14) be T filters?

https://www.daenotes.com/sites/default/files/article-images/T-filter.webp

https://www.mouser.com/ds/2/281/c51e-794816.pdf (page 128)

Did someone replace FL20 (and FL15) with the wrong part and end up shorting it to ground? Is the centre pin grounded (yes it is, I just reread the OP)??
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod