Hey guys,
I have tried to contact multiple Support Service Centres of California Instruments / Ametek that are listed on there website, but unfortunately none of them are responding on my question or the e-mail addresses are not correct
So I hope you can help me with a problem that I have with my 1501IX-230 AC and DC Power Source
The right most Amplifier control board keeps blowing op its end-stage is randomly.
My suspicion is that one of the Dip-switches is set wrong.
And I cannot figure out the right settings from the user-manual.
Model: 1501IX-230
P/N: 1501IXB0D4X0000 Rev:A
I use the unit standalone.
The settings I have now are:
Right (top) Amplifier control board:
S1: ALL OFF
S2: ALL OFF
S3: 1 OFF MRR
2 ON SLR
Left (bottom) Amplifier control board:
S1: NR 1 is on the rest is OFF
S2: ALL ON
S3: 1 OFF MRR
2 ON SLR
User manual:
https://atecorp.com/atecorp/media/pdfs/data-sheets/california-instruments-751_1501_i-ix_compact_user_manual_6005-960_revl.pdfI think dip switch S1 is set wrong on the left amplifier (top one on the picture)
(these are, as far as I know, 2 identical amplifiers in the master/slave mode)Page 107 :7.6.3.1 DIP SWITCH SETTINGS
DIP switch S1 selects which oscillator phase will drive each half bridge.
DIP SWITCH POSITION NAME FUNCTION
1 LA ON for LEFT = Phase A (LB, LC must be OFF)
2 RA ON for RIGHT = Phase A (RB, RC must be OFF)
3 LB OFF) ON for LEFT = Phase B (LA, LC must be OFF)
4 RB ON for RIGHT = Phase B (RA, RC must be OFF)
5 LC ON for LEFT = Phase C (LA, LB must be OFF)
6 RC ON for RIGHT = Phase C (RA, RB must be OFF)
But this manual needs a manual to read it.
So does anyone happen to know the settings or how I can get this info?
Thanks in advance!