« previous next »
Pages: [1]   Go Down

Author Topic: Office repair bench setup  (Read 865 times)

0 Members and 1 Guest are viewing this topic.

Offline ShockTopic starter

  • Super Contributor
  • ***
  • Posts: 4217
  • Country: au
Office repair bench setup
« on: March 19, 2020, 11:31:08 pm »
Just noticed this video and thought I'd share. Quite a tidy setup and interesting way to duct the fume extractor along with the microscope.

Logged
Soldering/Rework: Pace ADS200, Pace MBT350
Multimeters: Fluke 189, 87V, 117, 112   >>> WANTED STUFF <<<
Oszilloskopen: Lecroy 9314, Phillips PM3065, Tektronix 2215a, 314
 
The following users thanked this post: frozenfrogz

Offline ShockTopic starter

  • Super Contributor
  • ***
  • Posts: 4217
  • Country: au
Re: Office repair bench setup
« Reply #1 on: March 19, 2020, 11:37:55 pm »
Logged
Soldering/Rework: Pace ADS200, Pace MBT350
Multimeters: Fluke 189, 87V, 117, 112   >>> WANTED STUFF <<<
Oszilloskopen: Lecroy 9314, Phillips PM3065, Tektronix 2215a, 314
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee