Electronics > Repair
Oscilloscope is in a boot lock
<< < (4/4)
picburner:

--- Quote from: LoveLaika on July 29, 2024, 03:05:41 pm ---Thanks for replying, but I'm lost. How do you measure power supply voltages on the BNC input connectors? You can't simply connect a cable from the bad oscilloscope to another to measure the voltage, can you?

--- End quote ---

cncjerry probably meant the gold contacts "Around" the BNCs, which are the contacts that power the scope probes.
But your scope does not have these contacts, so you could not make such a measurement.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod