EEVblog Electronics Community Forum
Electronics => Repair => Topic started by: SG-1 on June 28, 2022, 07:28:00 pm
-
Hello friends, I am restoring an old Simpson 260 series 8M. Am looking for guidance on repairing the phenolic case. It is cracked & broken at one handle attachment point. Does anyone have any suggestions on an adhesive to reassemble the pieces? Will probably use fiberglass screen & epoxy inside to increase strength, just have to carefully watch clearances.
-
I would use epoxy for the general gluing too.
-
Epoxy (high strength slow cure) and good prep work, everything rough and degreased.
-
Not sure if this is what you need, but a new case back is only $19.86 here...
https://www.metersales.com/shop/product/03-320525r-31903?category=138&search=simpson#attr=43436,164312,151029 (https://www.metersales.com/shop/product/03-320525r-31903?category=138&search=simpson#attr=43436,164312,151029)