Electronics > Repair
philips 43pus7908/12 doesnt turn on
(1/1)
loordgek:
i have 12v 5v 3.3v 1.8v and 1volt
the standby led does not turn on
the tcon board does not get power, it is held back by a mosfet
https://alltransistors.com/mosfet/transistor.php?transistor=20438
at gate and source i have 12 volt but i dont know if if it is a NO or NC mosfet

if somebody has a schematic available  :-+
m k:
How is drain?

Take it out and short the holes.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod