Electronics > Repair
Please help, FLUKE 8920A Multimeter Repair
<< < (21/45) > >>
daisizhou:
I don't know if these 2 videos are helpful,Please check out the "TEST2" video.

It seems that "700" will only flash when no probe is connected at TP1.

thanks



daisizhou:
Hi Harry_22.

Did you find any new clues?Do you have any constructive suggestions?
Harry_22:
Hi!

You have created a resonant self-support (pls see attached photo). This may be due to the lack of a shielding cover. This is not normal operation.

Please give me a very good photo of the C13. To do this use any camera stand.
daisizhou:
I took several pictures,I don't know which one will suit your needs.



https://i.postimg.cc/153x9Q4q/33.jpg
https://i.postimg.cc/HsZqnh7P/44.jpg
https://i.postimg.cc/x1XWz3vj/P40528-185739.jpg
Harry_22:
The photos are good of course but I asked for a C13.
Please be more careful.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod