| Electronics > Repair |
| Please help, FLUKE 8920A Multimeter Repair |
| << < (6/45) > >> |
| daisizhou:
OK. this is a test video,The TP3 waveform looks a little different than before. Looking forward to your analysis or further testing. |
| Harry_22:
Perfect! I this video you catches 700V overload. I need some time to analyze the data. |
| daisizhou:
Ok thanks, I will wait for your results :-+ please allow me to say one more thing,The video below may have clues."LO RANGE ENABLE" button. https://www.eevblog.com/forum/repair/fluke-8920a-multimeter-repair-needs-some-help/ |
| Harry_22:
Yes your new video eplains my suggestion somewhat. Now please measure voltage at two points: |
| daisizhou:
I measured the voltage between GND-R1 and GND-VR1,If you mean the voltage between R1-VR1 please tell me and I will re-measure. thanks |
| Navigation |
| Message Index |
| Next page |
| Previous page |