Electronics > Repair
Please help, FLUKE 8920A Multimeter Repair
<< < (11/45) > >>
Harry_22:
No just touch it by hot iron through termal paste.
daisizhou:
Does it operate as shown in the picture below?To put it simply, the high-temperature heat is transferred through the soldering iron head to the C18 shell.
Then observe the changes in the 8920a display?
Harry_22:
This is not C18. C18 is a smaller one. Don't overheat it.
daisizhou:
OK.I will test the capacitor with the arrow pointing to it using your recommended test method.

I am doing this test while waiting for the 8920a to display "700" flashing, or "mv, v" flashing alternately.Because only in this way the changes will be more intuitive

Thanks
Harry_22:
You can do this test now by monitoring the readings.
Could you film this.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod