| Electronics > Repair |
| Please help, FLUKE 8920A Multimeter Repair |
| (1/45) > >> |
| daisizhou:
It looks like this triode is self-oscillating.I don't know how to adjust it for correct operation If anyone knows please tell me, thanks Service Documentatie www.bramcam.nl/8920/Fluke_8920A_8921A_Manual.pdf |
| Harry_22:
You marked operational amplifier A. Is it correct? |
| daisizhou:
I saw this sentence in the troubleshooting list.Did I identify it wrong? |
| wasedadoc:
What is the voltage at TP1? |
| daisizhou:
Please view the connection video here https://www.circuitsonline.net/forum/view/message/2506099#2506099 I tested the TP3 test point,TP1 and TP2 test points require removal of the shielding casing,If the shield case is disassembled, the 50 ohm load will be disconnected from the input.There will be interference in the input signal, so I was not able to accurately test the TP1 and TP2 test points |
| Navigation |
| Message Index |
| Next page |