please help me repair andonstar adsm302

[RAPER]

I have a problem with the andonstar adsm302 microscope. I haven't turned it on for half a year, and it turns out that after turning it on, it stops at the welcome screen. I copied the contents of the winbond 25q32 but nowhere is able to get another one. Is anyone able to copy from his ?? you don't even need to desolder it, all you need is a clip and ch341a. Please help, because I feel sorry for the equipment. Unless there is any possibility to use it with a hdmi monitor ?? greetings

[RAPER]

Thank you very much, I will check in the evening

[RAPER]

Hello again, PeDre, I am sending you photos from the logs in PuTTy, from what I can see, the main processor probably has a problem. I used CH341A for the logs. I have no idea how to deal with it. It can use only the telescope and the matrix from the camera, or some webcams.

[RAPER]

Wow you were right: o in the com port system settings, I had 9600 and no xor etc.

[RAPER]

You can turn on your microscope without the tape from the telescope matrix attached?

[RAPER]

Are you able to try ?? I could then rule out, soft etc.

[RAPER]

Thank you very much, I am sure that I had to break the cmos cable somewhere. I will have great fun locating: D

[SSaimor]

Hello.  You did it?  I am also in need.

I have a problem with the andonstar adsm302 microscope. I haven't turned it on for half a year, and it turns out that after turning it on, it stops at the welcome screen. I copied the contents of the winbond 25q32 but nowhere is able to get another one. Is anyone able to copy from his ?? you don't even need to desolder it, all you need is a clip and ch341a. Please help, because I feel sorry for the equipment. Unless there is any possibility to use it with a hdmi monitor ?? greetings