« previous next »
Pages: [1]   Go Down

Author Topic: Pulled this from an Amprobe meter today.  (Read 761 times)

0 Members and 1 Guest are viewing this topic.

Offline mendip_discoveryTopic starter

  • Frequent Contributor
  • **
  • Posts: 999
  • Country: gb
Pulled this from an Amprobe meter today.
« on: October 24, 2022, 07:08:16 pm »
This is the worst I have seen.





« Last Edit: October 24, 2022, 07:10:43 pm by mendip_discovery »
Logged
Motorcyclist, Nerd, and I work in a Calibration Lab :-)
--
So everyone is clear, Calibration = Taking Measurement against a known source, Verification = Checking Calibration against Specification, Adjustment = Adjusting the unit to be within specifications.
 
The following users thanked this post: EEVblog

Online Gyro

  • Super Contributor
  • ***
  • Posts: 10083
  • Country: gb
Re: Pulled this from an Amprobe meter today.
« Reply #1 on: October 24, 2022, 07:49:29 pm »
I suppose you can be grateful that it didn't leak at the connector end!
Logged
Best Regards, Chris
 

Offline mendip_discoveryTopic starter

  • Frequent Contributor
  • **
  • Posts: 999
  • Country: gb
Re: Pulled this from an Amprobe meter today.
« Reply #2 on: October 24, 2022, 08:21:50 pm »
It's an Amprobe meter, so I suspect it will be an improvement if it did leak all over the inside.
Logged
Motorcyclist, Nerd, and I work in a Calibration Lab :-)
--
So everyone is clear, Calibration = Taking Measurement against a known source, Verification = Checking Calibration against Specification, Adjustment = Adjusting the unit to be within specifications.
 
The following users thanked this post: Hamelec
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee