EEVblog Electronics Community Forum

Electronics => Repair => Topic started by: ElkoShop on October 31, 2016, 01:43:05 am

Title: QUAD 4C Pick and Place HHT
Post by: ElkoShop on October 31, 2016, 01:43:05 am

I have two QUAD machines, (DOS Controller) and cannot get the hand held to move the head on either machine.
It will home the machine, and I can read/modify MOD codes.

Is there a special sequence to key in for this?

Thanks  in advance,

Steve

Title: Re: QUAD 4C Pick and Place HHT
Post by: ElkoShop on October 31, 2016, 09:08:57 pm

I have the sequence.
Push "Pickup", "any number", "enter"

Then use arrow keys.  Add Ctrl for fast, Shift for medium speed.

Thanks to Bob at Precision-Repairs for the help.

Steve