Electronics > Repair
RadioShack FET VOM repair has me stumped
<< < (3/4) > >>
schmitt trigger:
I also had this same FET-VOM.
I loved it, but for a weird reason, the plastic pieces started to rot away. Disintegrating
into plastic dust.
First to go was the back case, but I could somehow mend it. That is, until the selector switch simply fell apart.
RichardM:
I have an assortment of meters:) but have been using a Fluke 87V, HP3468a and HP3478a. I also have 2 HP-410C I could try.

I have cleaned the rotary switch contacts well with IPA and a light sand with a fibreglass pen but will look at cleaning the meter more widely. Maybe the polarity switch is the culprit? I will report any changes.

Cheers
RichardM:
Ok, so it is not the polarity switch. I desoldered it and hard wired the polarity and I see the same behaviour on the 1M range.
floobydust:
How is R25, 5MEG?
With an eagle eye look for any crud, residue etc. anywhere inside the multimeter, as if a battery took a piss etc. Either you have contamination somewhere, or something is being glossed over. Look at the little JFET board too, it must be spotless. The wires along "G" as well.

A high Z multimeter i.e. HP3478A up to 3V range is 1010 ohms, you can measure the voltage drop across R25 as I keep thinking the input resistance is lower than it should be. 34401a has a high Z mode as well. Otherwise, the switch row is somehow leaky.
On Rx1MEG range, I would connect another multimeter and measure current at the test leads.
1.5V in 10MEG is only 0.15uA it's very little current in the first place.
RichardM:
I have been focussing on the little FET board. I think this may be where there is some contamination or something else. I have pulled the dual FET out for now.i have scrubbed it to death. I notice that touching and spraying alchohol around D and R25 while measuring across R19 send the resistance crazy.

R25 tests fine out of circuit. If I measure the resistance between the cathode of D1 and poitG on the other side of R25 I measure 2.7M one way and 4.8M the other way. The 2.7M is when I have the COM on the cathode. This is with the FET removed.

I will try to take some measurements ,nets as you suggest.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod