| Electronics > Repair |
| Raspberry pi 4 Model B Power Failure |
| (1/3) > >> |
| AmmarKurd:
Hello everyone, I have an RPi 4 model B that experienced a misfortunate accident while working on a robotics project, due to this the RPi didn't start afterward. I identified a short circuit on a component that I believe is a TVS diode its part number is (KE 2162K), it is also cracked as seen in the image below, but I couldn't find its datasheet anywhere online! I thought if it was really a TVS diode then I could just remove it from the board and it should work fine if not damaged, so I did. After removing it there is no more short circuit and the power LED lights up but the RPi does not boot, and the ACT LED does not blink. So, now I think maybe it is not a TVS diode? or my RPi is damaged? Is there anything I can do in this situation? any recommendations to try and save my RPi? Also, why can't I find the datasheet of this component? I appreciate any help I can get, so thanks in advance. |
| dobsonr741:
What was the misfortune event? BTW, the power manager MxL7704 is very sensitive to over voltage. |
| AmmarKurd:
I am not sure what exactly happened but some motor driver started to smoke, it might be incorrect wiring that caused it the pi was connected to the driver as well. |
| wasedadoc:
That is the TVS diode and it is the only one shown (top left corner with part number) on the reduced schematic available on the raspberrypi.com site. An otherwise OK RPi4B will work without the diode. That yours does not is a strong indicator that there is other damage which in almost all cases means the board is toast. |
| wraper:
Check all 4 output voltages (3.3V, 2x 1.1V and 1.8V) from MXL7704 or DA9090 depending on board revision. Also check if there is 1.1V from DA9121 if another smaller PMIC is present on the board. |
| Navigation |
| Message Index |
| Next page |