Electronics > Repair
repair Agilent E4402B Tracking Generator 3GHz
(1/1)
m2012:
I have a tracking generator in my E4402B that was flooded with water.
The BITG is a new type 5086-7993. I don't have any output level at all.
Inside the BITG is pure horror for anyone who wants to carry out an effective repair.
I cannot repair the output board in the BITG. This is because even if I had a machine for
bonding gold wires, it would be very difficult to buy components without a housing.
That's why I decided to recreate the BITG.
There was another post that was about a BITG for an E4407 that was built on normal PCB material.
I think there are probably other people with
the same problem.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod