EEVblog Electronics Community Forum

Electronics => Repair => Topic started by: azemati on January 29, 2023, 10:55:50 am

Title: Repair / Fluke 289 Error E4
Post by: azemati on January 29, 2023, 10:55:50 am
Greetings to all friends
I have a handheld multi meter fluke 289
Which unfortunately has been giving error E4 for some time
Now has anyone encountered this problem?
If you have a solution let me know so I can fix it.
Title: Re: Repair / Fluke 289 Error E4
Post by: bidrohini on January 30, 2023, 01:31:53 am
Have you checked page number 56 of this user manual? There appears to be a discussion about the error messages:
https://www.google.com/url?https://assets.fluke.com/manuals/287_289_umeng0100.pdf (https://www.google.com/url?https://assets.fluke.com/manuals/287_289_umeng0100.pdf)
Title: Re: Repair / Fluke 289 Error E4
Post by: coromonadalix on January 30, 2023, 02:05:35 am
On other fluke meter

The error 4 is an ADC error (Analog to Digital Converter). This is caused when the ADC is not converting or producing a usable signal to the controller. The ADC chip has gone bad.

???
Not sure it aplies to this one ?
Title: Re: Repair / Fluke 289 Error E4
Post by: azemati on January 30, 2023, 08:06:05 am
Thank you for your reply
I checked it but nothing was written about error E4
 :( :(
Title: Re: Repair / Fluke 289 Error E4
Post by: Ugur on February 02, 2023, 05:58:01 am
Can you share a picture of the error?
Title: Re: Repair / Fluke 289 Error E4
Post by: coromonadalix on February 02, 2023, 11:46:45 am
And the obvious question : have you contacted fluke ??
Title: Re: Repair / Fluke 289 Error E4
Post by: azemati on February 06, 2023, 07:35:55 am
Not yet