Electronics > Repair
Repair Siglent SDS1102DL
<< < (4/9) > >>
tautech:

--- Quote from: Bigfoot on July 28, 2015, 07:06:42 am ---I've performed the checks. All voltages on the power connector are within spec. The 3 frequencies measured spot on , 30MHz, 25MHz and 100MHz.

--- End quote ---
I've asked Siglent to re-visit this thread, let's see what advice they offer for your next step.
Bigfoot:
OK Thanks very much.

Siglent:
Hi Bigfoot,
please reinsert the cable between the display and mother board.
tec5c:

--- Quote from: Bigfoot on July 27, 2015, 11:33:33 pm ---I've updated firmware and reseated both ends of the flexcables with no change in the problem.

--- End quote ---


--- Quote from: Siglent on July 29, 2015, 03:05:29 am ---Hi Bigfoot,
please reinsert the cable between the display and mother board.

--- End quote ---

Hmm.
tautech:

--- Quote from: tec5c on July 29, 2015, 07:50:03 am ---
--- Quote from: Bigfoot on July 27, 2015, 11:33:33 pm ---I've updated firmware and reseated both ends of the flexcables with no change in the problem.

--- End quote ---


--- Quote from: Siglent on July 29, 2015, 03:05:29 am ---Hi Bigfoot,
please reinsert the cable between the display and mother board.

--- End quote ---

Hmm.

--- End quote ---
This is not to say Bigfoot has done this correctly.  :-//
These ribbon cables can be tricky to engage correctly and get all the way home and then get the retainer locked as well.

When I had a incorrect display problem with a similar unit under warranty Siglent sent a spare display ribbon cable along with other replacement parts.
However it was been the only warranty repair I have had to do on Siglent products.
Touch wood.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod