EEVblog Electronics Community Forum

Electronics => Repair => Topic started by: owiecc on September 08, 2023, 08:15:28 am

Title: Replacement pogo pins for Keysight 42941A
Post by: owiecc on September 08, 2023, 08:15:28 am

I need to replace a pogo pin that goes on the tip of the Keysight 42941A. Do you have a good distributor of these pins? Pin diameter is 0.67mm and the length is around 15mm (don't know precisely because all the pins I have are broken).

Keysight sells them but I would prefer a cheaper source ;) Keysight 42941-60004

Title: Re: Replacement pogo pins for Keysight 42941A
Post by: perdrix on September 08, 2023, 06:50:09 pm

I ordered a pack of 100 P50-B1 pogo pins from eBay for the grand sum of GBP3.35 (about USD4). ...

See this thread: https://www.eevblog.com/forum/testgear/spring-tips-for-pmk-pml-711-a-or-similar-(e-g-lecroy-pp008)/ (https://www.eevblog.com/forum/testgear/spring-tips-for-pmk-pml-711-a-or-similar-(e-g-lecroy-pp008)/)

David

Title: Re: Replacement pogo pins for Keysight 42941A
Post by: owiecc on September 14, 2023, 09:38:12 pm

Thanks, they do look very similar. Will try them and report back if they fit.