Electronics > Repair
Replacing nichicon Dual-C 10.000uF cap
(1/2) > >>
EifX:
Hi there,

I am restoring a Sony TA-2650 amp and came across a bad Nichicon Dual-C 10.000uF dual capacitor. See the attached picture.
I have searched the interweb for this but didn't find anything yet. Maybe I could replace this cap with 2 separate 10.000uF caps?
Does anyone have any advice on how to do this?

Thanks in advanced.
EifX 
coromonadalix:
you could  with "wearing gloves and visage protection"  open the capacitor and put 2 separate capacitors in it ?   for the look ??   or try to build a round pcb as a base and solder 2 caps on it, mimicking the pinout ?
EifX:
Did you perform this procedure yourself?
I find it a little rich for my taste  ;D. But i will consider it and think about it.

aqibi2000:
Find the gnd on the board and then put 2 caps

coromonadalix:
yep i did it   but  it was aluminum casing capacitors,  you could cut it near the botom edge ... but not necessarly applicable to a modern version ???

But try to find axial capacitors and hot glue them together and do the proper connections ??
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod