Electronics > Repair

Replacing nichicon Dual-C 10.000uF cap

(1/2) > >>

EifX:
Hi there,

I am restoring a Sony TA-2650 amp and came across a bad Nichicon Dual-C 10.000uF dual capacitor. See the attached picture.
I have searched the interweb for this but didn't find anything yet. Maybe I could replace this cap with 2 separate 10.000uF caps?
Does anyone have any advice on how to do this?

Thanks in advanced.
EifX 

coromonadalix:
you could  with "wearing gloves and visage protection"  open the capacitor and put 2 separate capacitors in it ?   for the look ??   or try to build a round pcb as a base and solder 2 caps on it, mimicking the pinout ?

EifX:
Did you perform this procedure yourself?
I find it a little rich for my taste  ;D. But i will consider it and think about it.

aqibi2000:
Find the gnd on the board and then put 2 caps

coromonadalix:
yep i did it   but  it was aluminum casing capacitors,  you could cut it near the botom edge ... but not necessarly applicable to a modern version ???

But try to find axial capacitors and hot glue them together and do the proper connections ??

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod