Electronics > Repair

Replacing unmarked SMD resistor

<< < (5/5)

inse:
I would scratch off charred resin, attach the new part with wires for stabilization, additionally you can place a blob of epoxy if you are afraid of vibration.

Swake:
Same here
Clean as much as possible. Stabilise and insulate the hole with epoxy.
Connect the part with new wires, fixed the part and the wires with small blobs of UV cured epoxy.

Bicurico:
Thanks to everyone!

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod