Author Topic: Rigol DP1308A Power Supply (Read 975 times)

DemasPPC · « **on:** August 22, 2024, 03:25:43 pm »

Hi, I'm looking for a calibration manual for this power supply or a password to start calibration

thm_w · « **Reply #1 on:** August 22, 2024, 11:42:55 pm »

Nothing here https://www.manualslib.com/manual/686673/Rigol-Dp1308a.html

Try 1111 or 11111.
Maybe 2009 or 2011 too. The DP832 password was 2012.

DemasPPC · « **Reply #2 on:** August 23, 2024, 01:59:43 am »

These codes don't look like, 12345, 1234, 1111-11111111, 2000-2024, 0000-00000000

bombcat · « **Reply #3 on:** September 12, 2024, 08:05:41 am »

password 666666
如果想要校准，只需要一个5 1/2或6 1/2精准的万用表。

thm_w · « **Reply #4 on:** September 12, 2024, 10:32:21 pm »

password 666666
如果想要校准，只需要一个5 1/2或6 1/2精准的万用表。

Quote

If you want to calibrate, all you need is a 5 1/2 or 6 1/2 accurate multimeter.

Thank you.
Though please translate your future posts to english as this is english forum.

Smokey · « **Reply #5 on:** September 13, 2024, 12:50:57 am »

password 666666
如果想要校准，只需要一个5 1/2或6 1/2精准的万用表。

Quote

If you want to calibrate, all you need is a 5 1/2 or 6 1/2 accurate multimeter.

bombcat · « **Reply #6 on:** September 14, 2024, 09:21:22 am »

OK！I try to translate it , but it's not always accurate.

DemasPPC · « **Reply #7 on:** October 02, 2024, 05:27:56 am »

Thank you all, unfortunately I couldn't check this code. I don't have this block at hand now, but I am very grateful to you and glad for your help

EEVblog Electronics Community Forum