Electronics > Repair

Rigol DP832 - Channel 1 Analog Board - Schematic Fragments

(1/2) > >>

pedro48:
Hi folks,

Attached is a start at mapping the DP832 Channel 1 Analog board,  Please be aware this work though mostly DONE is a bit incomplete, and there are possibly errors, but I could not find anything that looked like a schematic, so I've had a crack here ... several contributors to this forum assisted greatly in observations and explanations of how things should work for the DP832.

The attached KICAD schematic and PDF roughly follows the physical board in layout i.e. Left to Right, Top to Bottom. I have not made any attempt yet to ensure each trace is exactly aligned page to page, but they are all labelled so it should be readily traceable.

Hope this helps

cheers....

dwonga:
Thank you!

Yesterday my DP832 second channel blew up (not CH2 or CH3 are working). An error appears when I turned it on "Analog board fails self test", and looking info about the issue, the device sais "Lower board fails". I think the information you made will be extremelly helpful. Thanks again.

RoGeorge:

--- Quote from: pedro48 on January 09, 2022, 09:19:26 pm ---Attached is a start at mapping the DP832 Channel 1 Analog board

--- End quote ---

That's something I was curious about and didn't find anything yet, thank you very much!  :-+

Machlee:
Good job.
My DP832A does not turn off channel 1. Instead of turning it off, it is set to +33V.

Muttley Snickers:

--- Quote from: Machlee on March 29, 2023, 04:47:50 am ---Good job.
My DP832A does not turn off channel 1. Instead of turning it off, it is set to +33V.

--- End quote ---

The DP832 that pedro48 gave away also had a similar problem and unfortunately I haven't been able to give it the time or attention it probably deserves due to ongoing health concerns.

Regardless of what is shown in the display have you actually measured the output with a meter?

Navigation

[0] Message Index

[#] Next page