EEVblog Electronics Community Forum
Electronics => Repair => Topic started by: Mortys on November 17, 2022, 06:57:36 pm
-
Hello, I hope you can help me. I have a problem with my ds1052e. I send you screenshots. No channel measures me. There is only noise. It appeared from one day to the next.
-
estoy desesperado puedo mandar video
-
ahora se queda enm la pantalla de carga
-
Why do you have the timescale set to 50 seconds?!
-
Attach CH1 probe to the 1kHz signal output, hit Auto, and then discuss the results. Or probe some other known signal where you think you are seeing something that you shouldn't.
-
now it has stayed like that
-
try factory reset and if not see if you can flash it
proba reset de fabrica y si no fijate si podes flashearlo
-
how do you do a factory reset please
-
See page 2-3 of the service guide.
https://mcs-testequipment.com/content/files/Rigol-DS1000DE-Service-Guide.pdf
-
If that does not work, then reload the firmware.
You can download firmware for the DS1000E from Rigol.
https://www.rigolna.com/firmware/ (https://www.rigolna.com/firmware/)
Then
1.Copy .RGL file to the root of USB flash
2.Power on DS1000E/D/U, insert USB into DS1000E/D/U, there will be a note that find a new firmware whether to update. Press update button
3. After finish update ,reboot and check the version
Note: Do not power off the instrument or move the USB flash during the updating.
-
it does not recognize the usb it stays the same and some beeps sound
-
alIs there a thread on how to reprogram the eprom?
-
Maybe someone has more info. I found this:
https://www.eevblog.com/forum/repair/repair-bricked-rigol-ds1052e/ (https://www.eevblog.com/forum/repair/repair-bricked-rigol-ds1052e/)
-
Contact Rigol before you start trying to fix it yourself. They may have something that will boot from the USB drive. They were very helpful when I had a problem with my DS1054Z.
-
i also bricked mine... it can be programmed with JTAG J-Link, but since its unreliable, i bought XGecu programmer and desolder the Flash.. first it was out of calibration like in OP picture, yesterday i tried opening it again its now just blank, but i did save the Flash content, maybe later i'll try to reprogram again, i think something is rotten down after 10+ years of life.
https://www.eevblog.com/forum/blog/the-dark-side-of-the-rigol-hack-bricked-scope-how-to-fix-it/125/ (https://www.eevblog.com/forum/blog/the-dark-side-of-the-rigol-hack-bricked-scope-how-to-fix-it/125/)
Contact Rigol before you start trying to fix it yourself. They may have something that will boot from the USB drive. They were very helpful when I had a problem with my DS1054Z.
good luck, its 10+ yrs old DS1052E version.
-
Thanks everyone for your help
-
If you manage to repair it, let me know because the person who reprogrammed it for you is no longer here?
-
yes Drieg is missing. if he is around things will be much easier.