Electronics > Repair
Rilton Electronics Ltd 24012/E Variac
(1/1)
Mad Professor:
Good day, everyone.

This isn’t strictly a repair query, so please feel free to relocate this post to the most appropriate section if necessary.

I’ve recently acquired a used Rilton Electronics Ltd 24012/E Variac, and I’m seeking assistance and advice on how to wire it correctly.
The unit also has a label stating "Farnell No 393-1997," but I’ve been unable to find any manual or datasheet for it.

I’m based in the UK, where the supply voltage is nominally 230V with a tolerance of -6% to +10% (216.2V to 253.0V). However, my supply is at the upper end of this range and has occasionally reached as high as 257V.



I assume that the input supply will be across terminals 1 and 6, and the output will be between terminals 1 and 3.
Input Neutral = Terminal 1
Input Live = Terminal 6
Output Neutral = Terminal 1
Output Live = Terminal 3

Thank you for your time and any guidance you can provide.

Best regards.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod