Electronics > Repair
Rohde & Schwarz Signal Gerator SML-01, (FIXED)
<< < (9/10) > >>
charlyd:
Great SML topic this is. 

I am looking for the SML-Z2 utilty (1090.5203.02) for calibrating my SML generator.
Does anyone have this utility and is willing to share it here?

is there already a sort of "standard walkthrough" path for a not booting units related/refers to display problems?

EEngo:
does someone know where to find the firmware and/or the update utility? My SML has an EEPROM checksum failure, I'd like to fix that  :box:

Thanks!
Martin72:
Hi... ;)

A few days ago I used the sweep function of my SML01 for the first time, from 1Mhz to 1Ghz.
I noticed that between 1Mhz and just over 5Mhz the set 0dBm level is higher, after that it is exactly the same.
Is this a calibration problem or a defect or is it normal?
Spirex:
At some sweep switching time, this effect exists.
Spirex:
I'll duplicate the link. The archive contains dumps from microcircuits, and software from the manufacturer for programming the generator.

https://drive.google.com/file/d/1En2RaBFdwcJvHx7VV3AnrDAZthTMBvy8/view?usp=sharing

Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod