Electronics > Repair
Rohde & Schwarz SMIQ03B with Error 110 Output unleveled; IQMOD: ALC failure
jgorsk:
I also have a faulty SMIQ with the 110 error (Output unleveled; IQMOD: ALC failure) but the output stage amplifier seems to be working.
I suspect some filters between the frequency divider and tha output amplifier stage.
Attached are the spectra of the -10dB signal at 450MHz and 460MHz. The amount of harmonic tones at 460Mhz (and above) is way higher
than specified in the SMIQ documentation.
Could someone do me a favour and post the spectra of their SMIQ generator at -10dB and 450 and 460MHz please?
I'd like to see how those signals look like on a working generator.
rastro:
Hello jgorsk,
Which model of SMIQ do have (3,4,6??). It will probably make a difference. The 4/6 go through an additional PCB.
-rastro
jgorsk:
It's the SMIQ 02 model
rastro:
I've included the spectra for an SMIQ06 set to 450MHz and 460Mhz. I don't know if this will help since it has additional RF paths.
- rastro
jgorsk:
Thank you very much, that's what I needed to see.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version