Electronics > Repair

Rohde&Schwarz FSP HDD defect

<< < (3/3)

g7kbr67:
Hi Jörg

I have the same issue as you, my original drive was a flash card and I believe it was a Windows enterprise build. To cut a long story short, I fitted a SATA drive in as this had the two SATA cables which originally went onto a sub board which holds the flash card. 

I tried to install a fresh windows xp onto the SATA drive, this worked but I had a couple of issues with hardware, mainly drivers. I have this link for the complete drive I am sure I tried the NT version but it didn't work.   Believe the other one is a backup using a .rib format?

Spend so much time trying to get this to work, but at the moment its going in the recycling.

Any thoughts?

Regards

Paul

g7kbr67:
Hi Jorg

I have a FSP40 which had a corrupt flash drive.  I have installed the XP version you talk about from http://www.ko4bb.com/getsimple/index.php?id=manuals&dir=Rohde_Schwarz/Rohde_Schwarz_FSP the iso and installed on a SATA drive.  It boots but get a blue screen.  I see you got the NT version in the end; I have the issue of the tib file.  i don't have the 2016 software to extract the image.

I wonder can you help?

Regards

Paul

g7kbr67:
Hi Jorg

With reference the press of setup button to get into normal BIOS.  I couldn't see any reference to this in the service manual.

Can you confirm what else you need to press?  If I powerup the unit and press SETUP button, the unit peeps then goes to the menu to load analyser firmware etc.

I am still trying to check how the SAT drive is setup as?

Regards

Paul





--- Quote from: Jörg on November 17, 2021, 10:28:05 am ---
--- Quote from: Kosmic on November 06, 2021, 01:46:30 am ---On a similar note, does anybody know how to get in the bios ? the usual "del" or "f2" doesn't seem to work on the FSP.

--- End quote ---

Press the "SETUP" button after switching on the FSP. Then you get a normal bios.
A changed boot sequence e.g. A / C ... does not remain permanent. If necessary, this must be changed again at the next start.

I replaced the original HDD with a CF card with a CF to PATA adapter. Works wonderfully.

--- End quote ---

Harry_22:
Hi Paul,

do you still need FSP image?

g7kbr67:

--- Quote from: Harry_22 on September 06, 2024, 06:03:39 pm ---Hi Paul,

do you still need FSP image?

--- End quote ---

Hi Harry

I am still looking for  fsp40 IMAGE.

Regards


Paul

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod