| Electronics > Repair |
| R&S SMU200A calibration software |
| (1/2) > >> |
| drhex:
Hi all, I have a new (to me) SMU200A which I'd like to calibrate. I think there is a software package similar to the SMIQ which I can't find anywhere. Can someone please share that with me? Thanks, Florian |
| drhex:
Bump |
| squadchannel:
--- Quote ---External Adjustments Requiring Measurement Equipment The external adjustments require calibrated equipment and special software. Data sheet specifications of the unit are concerned. If required, contact your local Rohde & Schwarz representative. --- End quote --- It was mentioned in the service manual. you might want to contact Rohde. |
| drhex:
I have a ticket open with Rohde but am not hopeful. There is a tool for download in the software section to adapt levelling which could be the one but would like to know for sure. |
| KeBeNe:
Hi, yes, this is the right software, you need some prerequisites, I quote: "required: Mathworks Matlab Runtime Engine Version 7.14 (R2010B) (must be installed separately) Features: - R&S SMx-K63 User-defined frequency response correction for R&S SMU200A and R&S SMATE200A (requires SMx firmware 2.04.104.45 or higher). - Service frequency response corrections for R&S SMU200A, R&S SMJ100A, R&S SMATE200A, R&S SFU, R&S AMU200A, R&S AFQ100A and R&S AFQ100B. Further details and the devices required for the corrections can be found in the manual. For correct operation, we recommend the following installation sequence: 1. driver for the GPIB card. 2. National Instruments or Agilent VISA library (only required for remote control via USB or LAN). Recommended versions: - NI Visa 3.4 or higher - Agilent IO library M 01.01 or higher 3. Mathworks Matlab Runtime Engine Version 7.14 (R2010B). 4. SMx RF and BB correction toolkit. 5. NRP Toolkit and the NRP-Z driver for VXI Plug&Play (only required for NRP-Z). Recommended versions: - NRP Toolkit 1.5.7 or higher - NRP-Z VXIPnP driver 1.6.2 or higher." if you have found Mathlab 714, I would be interested in it. Edit: I have found Matlab 7.14, now I could install the R&S programme, to run it asks for the 7.14.SP2 and suitable DLL's... :-// |
| Navigation |
| Message Index |
| Next page |