Electronics > Repair

R&S ZVB8 VNA

<< < (5/5)

fjullien:
With the help of Harry, we found that the problem was a corrupted image on the hard drive.
It had nothing to do with any peripheral not being present....

I used a new image, copied my calibration settings and boom ! No problem anymore  :-+

Thank again Harry and Gerhard.

Franck.

Hamid:
hello sir
I have a ZVB8 that its HDD was crashed.
I need a copy of HDD image.

Gerhard_dk4xp:
Already answered the PM.

carver:
we repair Windows in our ZVH8 4-port, but lost calibration data.
try used calibration from ZVH8 2 port model, bus SW said that it's too incomplete(only port 1 and 2).
can anybody share factory.cal and factory.dat from any 4 ports ZVB (ZVB8 preffer) ?
thanks.


--- Code: ---Factory calibration data:
There is an individual factory calibration data set stored on each instrument which is
used when no special calibration is performed. This calibration data set has been taken
in the factory and consists of two files factory.cal and factory.dat.
These files are stored on the removable Compact Flash memory in the directory:
C:\Documents and Settings\All Users\Aplication Data\
Rohde&Schwarz\Nwa\Data\calibration
--- End code ---

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod