Electronics > Repair
R&S ZVB8 VNA
fjullien:
Hi,
I've got a ZVB8 VNA, it shows an error message when the application starts: "Hardware detection failed!"
Does anyone has a ZVB8 and can check if the device manager shows something more than mine (see attached screenshot) ?
I was thinking I could reverse the application to see what is checked before it starts but it's not the easiest way to start fixing this device...
Franck.
Gerhard_dk4xp:
I do have one, but its power supply is broken...
Gérard
Jarek:
Hello
Nice equipment, how much does something damaged like that cost?
I have been looking for a low budget VNA for some time now.
Where do you buy these?
Best regards Jarek
Gerhard_dk4xp:
I paid sth. like €10K + VAT for it in working order, had to
re-import it from Asia to Germany maybe 8 years ago.
I found a switch mode power supply for €1K + hefty
€500 for transport; someone else seems to have
bought it. >:(
BTW I copied the hard disk to a small SSD, block-wise.
So at least the software should be able to be recovered.
fjullien:
I didn't pay mine.
It came from another part of my company. During transport, it got broken.
I need to open it completely to see if I can spot something obvious.
Just opening the top and making a visual inspection shows nothing.
Navigation
[0] Message Index
[#] Next page
Go to full version