Electronics > Repair

Samsung tv repair

(1/2) > >>

snipersquad100:
Hi I got a Samsung ps43d490-a1w  The tv just blinks the red led when I switch on the power. I cant find a schematic on this set so I am stuck. How do I find out what board is the problem. |O

mariush:
Open it up, measure voltages, inspect components (see if there's bloated capacitors), see what happens when you push buttons (does the psu get out of stand-by?)

Check linear regulators on the boards, sometimes they fail...

Some Samsung tvs also have problems with corrupt eeprom chips... can't help you there though.

tom66:
X-main board 99% of time. Currently nonserviceable (replace board only) due to unknown failure cause.
When replacing X-main also replace Y-main and update TV firmware (bug in firmware kills X-main board.)
X-main responsible for common electrode of plasma display.

snipersquad100:
ok thanks

snipersquad100:
is it possible to rule out the power supply

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version