Electronics > Repair
Schematic help!!!
(1/1)
Crambone:
Can anyone tell me where the 26VDC starts and the path it takes by looking at this Power Supply Schematic?

Thanks, Andrew
Harry_22:
Your PS has PFC circuit. 26 volts takes from U2 T2. This is some kind of standby voltage.
asis:
Hi,

Apparently this is the PS RPS-1500-xx MEAN WELL line.
U7 (pin2, J2_2) gives +5V SB.
T3 (TIP122 Darlington) forms from +26V -> +13V to power the drivers U9 & U10 [Vcc 3] (UCC27424 s) of the inverter itself Q13;Q14;Q15;Q16 and has a switching circuit (HV-ON) Q11;Q12 that controls PWM module (PCB1 DC1500_CNTRL_BORD).
Q17; SCR1 & ZD1 - OVP.
It would be interesting to see the diagrams of the PFC & PWM modules themselves.
Kim Christensen:
Don't start multiple threads on the same topic! I already told you this in the other thread.   |O
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod