I apparently posted this is the wrong forum (test equipment). Sorry, newbie mistake.
I have an LC102 that I purchased new many many moons ago. I think I had it calibrated once by Sencore but other than that one time, it's been working fine. All of a sudden the display reads "Short" when testing a capacitor or zeroing "Open". I found L1 stuck, replaced it but that made no difference. Additionally I found the 2N6557 shorted. I replaced it with a NTE 171, but that also made no difference. I read 51 Ohms at the BNC so it's not an input short. I've seen others with this same issue, just wondering if anyone has found a solution.
Thanks,
Scott