| Electronics > Repair |
| Shaft Repair |
| (1/3) > >> |
| marnav1:
Hello Friends, Looking for the hard to find shaft coupler 376-0050-00/0051 (they are very similar) for a Tek T935a unit. Also would like to clean those stepped switches in the input section (ChA and B) but how to get the covers off? I see some nuts but I dont see how to access them, not sure how Tek managed it. Any help would be appreciated thanks. |
| jpanhalt:
Pictures of what you are trying to disassemble would help. Is this item from eBay the shaft coupler? https://www.ebay.com/itm/235738638186 Will generic flexible 1/8" (~3 mm) couplers work? |
| Gregg:
Without any details given by the OP, the first place I would look is McMaster-Carr: https://www.mcmaster.com/ |
| Ian.M:
That looks like to notched metal collars with grubscrews, round the ends of a piece of plastic with two bushings to fit the shafts with a cranked flexture joining the two halves. The metal collars are very unlikely to be broken so its likely that you can simply model the plastic part, taking measurements from the broken original and 3D print a replacement, preferably in a tough flexible material like PETG. |
| marnav1:
Trying to post a picture. I dont know how. Working on it. |
| Navigation |
| Message Index |
| Next page |