Electronics > Repair

Siglent oscilloscope screen SHS1102 frozen

(1/5) > >>

Alex2trois:
Hello everyone ;)

I have a broken Siglent SHS1102 oscilloscope, the screen remains blocked at startup, even when pressing the scop button, no reaction
Just once pressing the F1 key:
ver_soft 3.01.02.02r7
ver_hard: 8-21-3.3
Of course impossible to boot from a USB key
Do you have a solution to offer me?
I am not an electronics engineer but only an electrician
Is it possible to download the SHS1000 firmware and then load it with a programmer?
Can the RT809HSE programmer be used?
Thank you, see you soon

coromonadalix:
ask Tautech member here,  maybe there is some recovery procedures / package ...

Alex2trois:
Merci à toi Coromonadalix, je vais essayer :-+

coromonadalix:
Avec Plaisir    with pleasure

Donne nous en des nouvelles,  give us some news ...   :-+

tautech:

--- Quote from: Alex2trois on September 25, 2024, 08:08:47 am ---Hello everyone ;)

I have a broken Siglent SHS1102 oscilloscope, the screen remains blocked at startup, even when pressing the Scope button, no reaction

--- End quote ---
The only recovery method available in pressing SCOPE rapidly at Boot.

Try as many times as is necessary.

Download attached video.
Remove .txt extension required to upload .mp4 files to the forum.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod